Redsail — Cutting Plotter Software Installation

If your computer does not recognize the plotter when you plug it in, follow these steps:

Installing Redsail cutting plotter software requires loading USB/COM drivers, configuring communication ports in the Device Manager, and setting up compatible software like Artcut or Easy Cut Studio. Key steps include identifying the correct COM port and establishing connection with standard settings, such as a 9600 baud rate. For detailed setup instructions, visit Easy Cut Studio . Redsail Cutting Plotter User Manual for USB Port - emoc

Drop a comment below and let me know which Redsail you are using (e.g., RS-720, SC-6310A) and your operating system version.

Open Device Manager (Win+X → M). Under “Ports (COM & LPT),” you should see “Redsail Virtual COM Port (COM3)” or similar. If you see a yellow exclamation, skip to the Troubleshooting section. redsail cutting plotter software installation

If the software says "Cannot open port", check if another program is using that COM port.

Before opening your design software, you must install the drivers that allow your PC to communicate with the plotter via USB or Serial connection.

Method B: Installing Easy Cut Studio (Recommended for Modern Windows/Mac) Easy Cut Studio offers a straightforward setup for Redsail. Download Easy Cut Studio and install it. Add Cutter: Go to Cutter -> My Cutter -> Manage Cutters . If your computer does not recognize the plotter

Note the assigned port number (e.g., ). You will need this number later. 2. Installing and Configuring ArtCut

: Ensure Windows 7, 10, or 11 is fully updated.

This is where most users go wrong. Install the driver so Windows recognizes the plotter hardware. Redsail Cutting Plotter User Manual for USB Port

Before installing, ensure you have the following ready to prevent errors: Turn on the plotter. USB Cable: Connected between the plotter and the computer.

Place a piece of vinyl into the plotter and secure it.

If you are on a Mac or want a user-friendly interface, Easy Cut Studio is fully compatible with Redsail . Download and install Easy Cut Studio. Select from the cutting machine list. Select the COM port. Click "Cut" to start the project. Troubleshooting Common Installation Issues

Modern operating systems sometimes block older Redsail drivers due to strict digital signature enforcement. You can resolve this by restarting your computer in Disable Driver Signature Enforcement mode, then running the CH340 or FTDI driver installer again.